Delem
V1101, 2.11
Disabling software options
The software option can simply be disabled by selecting the software option number and
entering the option code. This is the same option code as you have used to enable the software
option. The ‘√’-sign will disappear.
2.11 Leaving the machine parameters menu
When leaving the machine parameters menu, beware of two things.
• The control checks if all programmed axes are properly assigned to DM modules. If this is
not the case, the control issues a warning. See also chapter 4.
• If no machine parameter has been changed, the control returns to the main menu. If any
parameter has been changed, the control will reset. If ‘enter’ is pressed while the cursor is on
a machine parameter, the control will assume this parameter has been changed and will reset
itself when the menu is left.
To Next Page
Loading...
