Delem
V0802, 3.121
Parameter 121: Sequencer from floppy on/off 1/0
Range : 0 - 1
Default : 0
Units : -
Function
To read the sequencer file from floppy.
Description
During development and testing of sequencer files it can be helpful to read this file from floppy
instead of loading a complete new application.
0 = using sequencer file from the internal application
1 = loading sequencer file from floppy
Press the key to select the required setting.
With this parameter set to 1 the sequencer file is only read from floppy during start up.
After testing the sequencer file you should set this parameter to 0 again. Make sure the required
sequencer file is on the application floppy with the other files and execute the normal application
load procedure.
To Next Page
Loading...
