Delem
V0802, 3.122
Parameter 122: Sequencer debug on/off 1/0
Range : 0 - 1
Default : 0
Units : -
Function
To activate the sequencer debug facility. Press the key to select the required setting.
Description
When the sequencer debug facility has been switched on (=1) a soft key appears in the manual
mode. Activating this key will generate a test row on top of the screen. In this row you can check
the equations of the sequencer. This test row overwrites the service row (in case the service row
is active).
Figure 122.a
To Next Page
Loading...
