Operation Section
- 27 - EN
MTL202DSLP
Stop the vacuum motors by pressing the relevant
STOP
buttons.
Warning!
Disconnect the plug from the power socket.
➢ Use two clamps to fasten the collection bag at two points (about 3 – 5 cm. from each other),
just below the filter chamber.
➢ Cut off the bag in the position between the two clamps.
➢ Remove the lower part of the bag.
➢ Pull down a length of new bag from the chamber, until it reaches the bottom support plate
Attention!
Used bags should be disposed of into a special waste disposal container, in accordance with
laws applicable in the country where the vacuum cleaner is used.
To Next Page
Loading...
