Delfin MTL202DS - Troubleshooting; Spare Parts Section

Spare parts Section
- 35 - EN
4.5 Troubleshooting
Fault found
Possible fault
Recommended remedy
The cleaner fails to start
No power
Thermal magnetic switch
tripped
Check the power mains
supply
Check the integrity of the
plug and power cable
Reset the thermal magnetic
switch
Dust is leaking out
Perforated vacuum pipe
Perforated filter
Filter unsuitable for type of
job
Replace the pipe
Replace the filter
Fit a suitable filter for the
type of material to be
vacuumed
The vacuum cleaner does not work as it
should
Pipe perforated or blocked
Container full
Filter blocked
Seals worn
Air leak
Check the pipe and, if
necessary, replace it
Empty container
Clean the filter and if
necessary change it.
Check the seals and, if
necessary, replace it
Check for any air leaks out
of closing fasteners,
tightening screws, container
or filter chamber
Motor very noisy.
Contact DELFIN after-sales
Warning!
For any other problems, contact the DELFIN after-sales service.