54
Go to Storage > Migration again to view the migration session and a high level view of its properties and state.
Note: During an NDM migration, the source of the migration will be an R2 or an R21 device (if there is existing SRDF DR
replication from the source device) and the target will be an R1 device. This is different than basic SRDF operations and
is required to allow DR protection during a migration using a cascaded SRDF configuration. See the section entitled
“ADDING DISASTER RECOVERY TO THE TARGET ARRAY” for more details.
PowerPath shows all paths to the source and target devices as alive. HYPERMAX OS will ensure that all I/Os that are directed to the
target array by the host are actually serviced by the source array until the cutover.
The paths will all remain in an alive state until after the commit operation.
VIEW MIGRATION SESSION DETAILS
Double Click the migration session to view details about it and the groups that the volumes, ports, and initiators belong to. For more
information, the view and groups on the left side of the GUI can be selected and will display details on the right side. In this case, the
port group is selected. Selecting "View Volumes" will show the source and target device pairs.
To Next Page
Loading...