Dell EMC VMAX - Perform a Rescan Following a Cancel; Perform a Cutover to the Target Array

59
PERFORM A RESCAN FOLLOWING A CANCEL
Following the cancel operation, the host paths to the target array are no longer available. The host systems administrator should
perform a rescan to remove the dead paths to the target array.
PERFORM A CUTOVER TO THE TARGET ARRAY
Prior to this step, the migration session that was cancelled in the last step was simply created again. The host also rescanned for
devices, so the pairs are in a CutoverReady state.
To cut the storage group over to the target, click Cutover.