63
Figure 12. CutoverSynchronized
Following a cutover, the two paths to the source array are inactive (FAs 7e:00 and 8e:00) and the four paths to the target are
active. In PowerPath, the terms used are "dead" and "alive".
Note: The PowerPath mode is "active" for all paths. This is a PowerPath term and is unrelated to the active and inactive
path states in NDM terminology. PowerPath will show the state of the path and whether it is alive or dead in the
“state” field.
Following the cutover, two paths are dead and the devices are degraded.
To Next Page
Loading...