36 Setting up Network Printing
9.
On the
Printer Software
screen, specify the software that you want to install and installation
path, and then click
Next
. At this point, the wireless setting specified on the
Enter Wireless
Network Settings
screen is sent to the printer.
10.
On the
Wireless configuration is now complete
screen, change the wireless setting of your
computer to the same as that sent to the printer, and then click
Next
.
a.
Select
Network Connections
from Control Panel.
b.
Right-click
Wireless Network Connection
and select
Properties
.
c.
Select the
Wireless Network
tab.
d.
Click
Advanced
.
e.
Do either of the following:
When wireless ad-hoc mode is set to the printer:
Select
Computer to Computer (ad hoc) networks only
and close the
Advanced
dialog
box.
When wireless infrastructure mode is set to the printer:
Select
Access point (Infrastructure) networks only
and close the
Advanced
dialog box.
f.
Select the setting that you send to the printer in the list in
Preferred Network
group.
g.
Click
Move up
to move the setting to the top of the list.
h.
Click
OK
to close the
Property
dialog box.
11.
On the
Setting-Ready Printer
screen, verify that the correct IP address is assigned to the
printer to which the wireless setting is set, and then click
Install
.
12.
If you select the
I am setting up this printer on server
check box on the
Select Printer
screen
and also select the
PostScript Driver
check box on the
Enter Printer Settings
screen, the
Adobe Systems Inc. License Agreement
screen appears. Select the
I accept the terms of the
license agreement
option button, and then click
Install
.
13.
On the
Congratulations!
screen, click
Finish
to complete the installation. A test page will be
printed with the installed printer by clicking the
Print Test Page
button.
Scene 2. Construct new wireless network environment for both computer and printer (When wireless
setting needs to be set to your computer)
1.
Insert the
Drivers and Utilities
CD into your computer to launch the installation software.
NOTE: If the CD does not automatically launch, click Start → Run, and then type D:\setup.exe (where D
is the drive letter of your CD), and then click OK.
2.
Select the
Network Installation
option button, and then click
Next
.
3.
Select the
Configure Wireless Printer using a wireless connection (Advanced)
option
button, and then click
Next
.
To Next Page
Loading...
