Dell 3110CN - Adding a Printer on Mac os X 10.3 or Earlier Version(S)

Installing the PPD File on Macintosh Computers 53
Adding a Printer on Mac OS X 10.3 or Earlier Version(s)
1. Turn on the printer.
2. If you use the USB port, connect the USB cable between the printer and the Macintosh
computer.
3. Start Print Center (or Printer Setup Utility ). The Printer List screen appears.
NOTE: When using Mac OS X 10.2.8, you can find Print Center in the Utilities folder in Applications.
NOTE: When using Mac OS X 10.3 or later, you can find the Printer Setup Utility in the Utilities folder in
Applications.
NOTE: When using Mac OS X 10.2.8, and connecting the USB cable to your computer with the power on,
the print queue, which uses a generic PPD file, is automatically created. Make sure to delete it.
4. Click Add .
When Using USB
1. Select USB from the menu, and then select your printer from the list.
2. For Mac OS X 10.2.8, select Dell from Printer Model .
For Mac OS X 10.3 or later, your printer model is automatically selected for
Printer
Model
.
3. Click Add .
When Using AppleTalk
NOTE: A multi protocol card must be installed to use AppleTalk. Refer to the User's Guide for installation
instructions.
1.
Select AppleTalk from the menu, and specify the zone for the printer being used.
2. Select your printer from the list.
3. Select Auto Select from Printer Model .
4. Click Add .
When Using IP Printing
NOTE: A multi protocol card must be installed to select IP Printing. Refer to the User's Guide for
installation instructions.
1.
Select IP Printing from the menu, and type the IP address for the printer being used in
Printer Address.