Contents 5
Redundant Path With Static Load
Balancing Support
. . . . . . . . . . . . . . . . . 37
Using Replace Member and Revertible
Hot Spares
. . . . . . . . . . . . . . . . . . . . . 37
Patrol Read
. . . . . . . . . . . . . . . . . . . . . . . . 38
Patrol Read Feature
. . . . . . . . . . . . . . . . 38
Patrol Read Modes
. . . . . . . . . . . . . . . . . 39
4 Installing and Configuring Hardware . . . 41
Installing the PERC 6/E and PERC 6/i Adapters . . . . . 41
Installing the Transportable Battery Backup
Unit (TBBU) on PERC 6/E
. . . . . . . . . . . . . . . . . 46
Installing the DIMM on a PERC 6/E Adapter
. . . . . . 47
Transferring a TBBU Between Controllers
. . . . . . . 48
Removing the PERC 6/E and PERC 6/i Adapters
. . . . . 49
Removing the DIMM and Battery from a
PERC 6/E Adapter
. . . . . . . . . . . . . . . . . . . . 52
Disconnecting the BBU from a PERC 6/i Adapter
or a PERC 6/i Integrated Controller
. . . . . . . . . . . 54
Setting up Redundant Path Support on the
PERC 6/E Adapter
. . . . . . . . . . . . . . . . . . . . 55
Reverting From Redundant Path Support to Single
Path Support on the PERC 6/E Adapter
. . . . . . . . . 58
Removing and Installing the PERC 6/i and CERC 6/i
Integrated Storage Controller Cards in Dell
Modular Blade Systems (Service-Only Procedure)
. . . 59
Installing the Storage Controller Card
. . . . . . . 60
Dell_PERC6.2_UG.book Page 5 Wednesday, June 24, 2009 6:08 PM
To Next Page