8-16 Dell PowerEdge 6100/200 System Installation and Troubleshooting Guide
7. Replace the left computer cover, reconnect the
computer and peripherals to their power sources,
and turn them on.
8. Enter the system setup program to confirm that
the RTC chip is operating properly.
Enter the correct time and date through the system
setup program’s System Time and System Date cate-
gories on the Main menu. Also reenter any system
configuration information that is no longer displayed
on the system setup screens, and then exit the system
setup program. See Chapter 4, “Using the System
Setup Program,” in the system User’s Guide for
more information.
9. Turn the computer and peripherals off, and leave
them off for at least an hour.
10. After an hour, turn on the system and enter the
system setup program. If the time and date are
still incorrect, see Chapter 11, “Getting Help,” for
instructions on obtaining technical assistance.
To Next Page
Loading...
