1. Disassembly Procedures
S1
Turn off the monitor.
S2
Place the monitor on a soft cloth or
cushion.
Carefully slide and remove the I/O cover
from the monitor
S3
Disconnect the cables from the monitor
and slide them out through the
cable-management slot on the stand
riser.
S4
Press and hold the stand release
button.
S5
Lift the stand up and away from the
monitor
S6
Unlock 4 screws on Rear Cover
Use hands or scraper bar to
disassemble Rear Cover from monitor
Notice the disassembly order :
Bottom Side=>Right/ Left Side=> Top
Side
(Screw Torque:10.5±1kgf)
S7
Remove USB FFC Cable and Audio
FFC cable from the I/F BD
S8
Remove CTRL FFC Cable from I/F BD
Tear off an adhesive tape and remove
the LED Driver BD wire from I/F BD
To Next Page
Need help?
General