Dell CX4 Series - Page 32

32 Cabling Your Cluster Hardware
Figure 2-12. Cabling a SAN-Attached Cluster to the Dell\EMC CX4-960
Cabling Multiple SAN-Attached Clusters to a Dell/EMC Storage System
To cable multiple clusters to the storage system, connect the cluster nodes to
the appropriate Fibre Channel switches and then connect the Fibre Channel
switches to the appropriate storage processors on the processor enclosure.
For rules and guidelines for SAN-attached clusters, see the Dell Cluster
Configuration Support Matrix on the Dell High Availability website at
www.dell.com/ha.
NOTE: The following procedures use Figure 2-10, Figure 2-11, and Figure 2-12 as
examples for cabling additional clusters.
0 1 23 0 1 23
01230
0
1
1
23
01
sw0 sw1
cluster node 2cluster node 1
Fibre Channel switch
01
01
HBA ports (2)
SP-A
HBA ports (2)
Fibre Channel switch
SP-B
CX4-960 storage system