2. Install the:
a. 2.5 inch hard drive assembly
b. Side cover
3. Follow the procedure in After working inside your computer.
Optional module
Removing optional module
1. Follow the procedure in Before working inside your computer.
2. Remove the :
a. Side cover
b. 2.5 inch hard drive assembly
3. To remove the optional card:
a. Disconnect the optional-card cable from the connector on the system board [1].
b. Remove the two (M2X3.5) screws and two screws that secure the optional card to the system chassis [2, 3].
58 Disassembly and reassembly
To Next Page
Loading...
