Dell D18M - Installing the Power Supply Unit (PSU); Removing the VGA Daughter Board

Installing the power supply unit (PSU)
1 Insert the PSU into the PSU slot and slide it toward the back of the computer until it clicks into place.
2 Tighten the screws to secure the PSU to the computer.
3 Route the PSU cables through the retention clips.
4 Connect the PSU cables to the connectors on the system board.
5 Close the front bezel door.
6 Install the:
• bezel
• cover
7 Follow the procedure in After Working Inside Your Computer.
Removing the VGA daughter board
1 Follow the procedure in Before Working Inside Your Computer.
2 Remove the:
• cover
• bezel
3 Open the front bezel door
4 To remove the VGA daughter board:
a Remove the screws that secure the VGA connector to the computer [1].
b Slide the VGA connector to release it from the computer [2].
c Remove the screw that secures the VGA daughter board to the computer [3].
d Lift the VGA daughter board using the handle to remove it from the computer [4].
Removing and installing components 15