Installing the VGA daughter board
1 Align the VGA daughter board with the screw holder on the system board.
2 Tighten the screw to secure the VGA daughter board to the system board.
3 Insert the VGA connector into the slot at the back of the computer.
4 Tighten the screws to secure the VGA connector to the computer.
5 Close the front bezel door.
6 Install the:
• bezel
• cover
7 Follow the procedure in After Working Inside Your Computer.
Removing the intrusion switch
1 Follow the procedure in Before Working Inside Your Computer.
2 Remove the:
• cover
• bezel
3 Open the front bezel door.
4 To remove the intrusion switch:
a Disconnect the intrusion switch cable from the connector on the system board [1].
b Unroute the intrusion switch cable from the fan grommet [2].
c Slide the intrusion switch and lift it away from the computer [3].
Removing and installing components 16
To Next Page
Loading...
