Installing the 2.5-inch hard drive assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the 2.5-inch hard drive assembly and provides a visual representation of the
installation procedure.
Steps
1. Insert the hard drive assembly into the slot on the computer until it clicks into place.
2. Connect the hard drive data and power cables to the connectors on the 2.5-inch hard drive modules.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Removing and installing Customer Replaceable Units (CRUs)
45
To Next Page
Loading...
