3.5-inch hard drive
Removing the 3.5-inch hard drive assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
About this task
The following images indicate the location of the 3.5-inch hard drive assembly and provide a visual representation of the removal
procedure.
Steps
1. Disconnect the data and power cables from the 3.5-inch hard drive module.
2. Remove the fours (#6-32) screws that secure the hard drive to the chassis.
3. Remove hard drive away from the chassis.
46
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
