Adding Parts 65
8 After the hinge arms clip into place, lower and raise the arms two or
three times to properly seat them.
9 Reattach the front-panel insert.
10 Reconnect the power cable to your computer.
11 Reattach the front door as described on page 62.
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions listed in "When Working Inside Your
Computer" on page 12.
1
Shut down the computer (see page 20).
2 Turn off any attached devices and disconnect them from their
electrical outlets.
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network wall jack.
3
Disconnect the computer power cable from the wall outlet, and then
press the power button to ground the system board.
To Next Page
Loading...
