90 Removing and Installing Parts
www.dell.com | support.dell.com
3
Press in on the tabs on each side of the hard drive bracket in the empty drive bay and slide the
bracket up and out.
4
Snap the hard drive bracket onto the new hard drive.
NOTICE: Do not install any drive into the lower hard-drive bay until you have removed the hard drive
bracket from the inside of the hard drive bay.
5
Slide the new hard drive into empty bay until you feel a click.
NOTE: If your replacement hard drive does not have the hard drive bracket attached, remove the
bracket from the old hard drive by unsnapping it from the drive. Snap the bracket onto the new hard
drive.
6
Gently slide the drive into place until you feel a click or feel the drive securely installed.
hard drive
hard drive bracket
To Next Page
Loading...
