80 Removing and Installing Parts
9
If you replaced a card that was already installed in the computer and you removed the retention
mechanism, you may reinstall the retention mechanism.
10
Before replacing the card retention mechanism, ensure that:
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the alignment guide.
11
Snap the card retention mechanism into place, securing the x16 PCI card.
1 alignment bar 2 fully seated card 3 not fully seated card
4 alignment guide 5 bracket within slot 6 bracket caught outside of slot
2
6
5
4
1
To Next Page
Loading...
