Removing and Installing Parts 93
Floppy Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
removing the cover.
NOTE: If you are adding a floppy drive, see "Installing a Floppy Drive" on page 94.
Removing a Floppy Drive
1
Follow the procedures in "Before You Begin" on page 59.
2
Remove the drive panel (see "Removing the Drive Panel" on page 83).
3
Disconnect the power and data cables from the back of the floppy drive.
NOTE: If you have installed a PCI Express x16 card, this card may cover the floppy-drive connectors. Remove this
card before connecting the floppy-drive cables.
4
Slide the drive latch release toward the bottom of the computer and, without releasing the drive latch
release, slide the floppy drive out through the front of the computer.
1 power cable 2 data cable
1
2
To Next Page
Loading...
