Dell Dimension V333c - Page 42

3-6 Dell Dimension V xxx and V xxx c Systems Service Manual
Keyboard control-
ler error
Keyboard controller
failed its test.
Enter system setup
program and restore
original value(s);
replace keyboard or
system board.
Keyboard error
Keyboard not working
correctly.
Replace keyboard or
system board.
Keyboard error
nn
BIOS detected a stuck
key represented by
scan code
nn .
Check keyboard; if a
key is stuck, pry it up.
Mouse initialized
System’s mouse found
and initialized.
No action necessary.
Operating system
not found
Operating system can-
not be located on drive
A or C.
In system setup pro-
gram, confirm that
drive A or C is properly
identified.
Parity check 1
nnnn
Parity error detected on
system bus. BIOS
attempts to locate
address and display it
(
nnnn ); if BIOS cannot
locate the address, it
displays ???? instead.
Enter system setup
program and restore
original value(s).
Parity check 2
nnnn
Parity error detected on
I/O bus. BIOS attempts
to locate address and
display it (
nnnn ); if BIOS
cannot locate address,
it displays ???? instead.
Enter system setup
program and restore
original value(s).
Press <F1> to
resume, <F2> to
enter Setup
Message displayed
after any recoverable
error message.
Press <F1> to start
boot routine or <F2>
to enter system setup
program and change
any settings.
Press <Del> to
enter Setup
Optional message dis-
played during POST.
Press <Del> to enter
system setup program.
Previous boot
incomplete -
Default
configuration
used
After unsuccessful
boot, POST loads
default values and
offers to run system
setup program. (POST
does
not input default
values to system setup
program.)
Run system setup
program and restore
original value(s). If
message reappears,
set system configura-
tion jumper to
Maintenance mode;
boot system to clear all
system setup value(s)
to their defaults.
7DEOH  6\VWHP 0HVVDJHV

FRQWLQXHG

0HVVDJH 3UREDEOH &DXVHV &RUUHFWLYH $FWLRQ