Dell Dimension V333c - Replacing the Battery

Removing and Replacing Parts 4-25
5HSODFLQJWKH%DWWHU\
)LJXUH  %DWWHU\ 5HPRYDO
The computer uses a 3-V CR2032 coin-cell battery. To remove the battery, fol-
low these steps:
1. If possible, enter the system setup program (see Appendix A, “System
Setup Program,” for instructions) and print the setup screens by pressing
the <Print Screen> key.
2. Remove the computer cover and support beam.
3. Remove the battery by prying it out of its socket with your fingers or a
blunt, nonconductive object, such as a plastic screwdriver.
To replace the battery, follow these steps:
1. Install the new battery with the “+” side facing up, as shown in
Figure 4-23.
2. Start the system setup program, and reset the System Date and System
Time options.
3. Compare the system configuration settings, and restore any system con-
figuration information that was lost while replacing the battery.
:$51,1*
7KHUH LV D GDQJHU RI D QHZ EDWWHU\ H [SORGLQJ LI LW LV LQFRUUHFWO\
LQVWDOOHG 5 HSODFH WKH EDWWHU\ RQO\ ZLWK WKH VDPH RU HTXLYDOHQW
W\SH UHFRPPHQGHG E\ WKH PDQXIDFWXUHU 'LVFDUG XVHG EDWWHULHV
DFFRUGLQJ WR WKH PDQXIDFWXUHU·V LQVWUXFWLRQV
battery socket
(
BT9K1)
battery