Dell E Series - User Manual

Dell
®
E Series Monitor VESA
Mounting Bracket Installation
Instructions
The VESA mounting bracket enables a Wyse cloud client to be mounted to the Dell E
Series Monitor. The bracket attaches to the monitor (a #1 Phillips-head screwdriver is
required), the cloud client is inserted in a vertical position, and then cables are
attached.
Note: If using a 22- or 23-inch Dell E Series Monitor, the monitor base extension must
be used.
Note: If using an E2414 Monitor, the P series mounting bracket must be used.
Wyse Cloud Clients Using this Bracket
Wyse models D class, P25, and T class may use the Dell E Series Monitor VESA
Mounting Bracket. (Shown below are D and T class on monitors having the attached
base extension.)
Note: Mount the cloud client only as shown; improper orientation (where the back
panel or front panel is facing down) could restrict the airflow of heat from the device
and damage it.
Note: Do not enclose the cloud client in a confined environment without proper
ventilation.

Summary

Dell E Series Monitor VESA Mounting Bracket Installation

Wyse Cloud Clients Using this Bracket

Identifies compatible Wyse cloud client models (D, P25, T) and provides mounting tips.

Mounting the Base Extension to the 22- and 23-inch E Series Monitor

Mounting the D Class to the E Series Monitor

Mounting the Wyse P25 and T Class to the E Series Monitor

Dell E Series Specifications

General

Panel Type	IPS or TN
Response Time	5ms or 8ms (varies by model)
Ports	HDMI, DisplayPort, VGA, USB (varies by model)
Screen Size	27-inch (varies by model)
Refresh Rate	60 Hz
Aspect Ratio	16:9
Contrast Ratio	1000:1 (varies by model)
Viewing Angle	178° horizontal / 178° vertical (for IPS models)
Color Support	16.7 Million Colors
VESA Mount	100x100mm
Resolution	1920x1080 (depending on the specific model)