DELL E1920H Teardown Instruction 1
1
Chapter 8-TEARDOWN INSTRUCTION
Remove Rear Cover Screw and Stand
Screws
a. Remove screws “1~4” on rear cover with
electric screwdriver
b. Remove stand screws “5” and “6”.
Torque: 12.0 +/- 0.5Kgf/cm
Remove Aluminium Foil and Acetate Cloth
Tape
a. Remove aluminium tape in “1~3” order
b. Remove acetate cloth tape marked with “4”
a. Panel side up, remove front panel with
both hands in sequence of “1->2->3”,
then “1->4->5->6”.
Remove Light Bar and Keypad Cable:
a. Remove light bar “1” (grasp on Pin then pull
upwards to remove)
b. Remove KP cable “2” (lift cover before
remove KP cable)
3. Remove Rear Cover:
a. Turn monitor to rear side up, remove
rear cover.
6. Remove FFC：
a. Pinch on clips on the sides, and remove FFC
b. Remove assembled chassis from panel
To Next Page
