Connecting Your Monitor
WARNING: Before you begin any of the procedures in this section,
follow the Safety Instructions.
To connect your monitor to the computer:
1. Turn o your computer and disconnect the power cable.
2. Connect either the white (digital DVI-D) or the blue (analog VGA)
display connector cable to the corresponding video port on the back
of your computer. Do not use both cables at the same time. Use both
the cables only when they are connected to two dierent computers
with appropriate video systems.
Connecting the blue VGA Cable
Connecting the white DVI cable
Note: The graphics are used for the purpose of illustration only.
Appearance on the computer may vary.
Setting Up the Monitor
25
To Next Page
Loading...
