Dell E5500 - Latitude - Core 2 Duo 2.53 GHz - Page 19

Replacing the E5400 Display Inverter


1. Connect the two display inverter connectors to the display inverter.

2. Replace the M2.5 x 5-mm screw that secures the display inverter.

3. Replace the display bezel (see Replacing the E5400 Display Bezel).

4. Replace the display assembly (see Replacing the E5400 Display Assembly).

5. Replace the keyboard (see Replacing the Keyboard).

6. Replace the hinge cover (see Replacing the Hinge Cover).

7. Close the display and turn the computer over.

8. Replace the bottom of the base assembly (see Replacing the E5400 Bottom of the Base Assembly).

9. Follow the procedures in After Working on Your Computer.
E5400 Display Panel

Removing the E5400 Display Panel


1. Follow the instructions in Before Working on Your Computer.

2. Remove the hinge cover (see Removing the Hinge Cover).

3. Remove the keyboard (see Removing the Keyboard).

4. Remove the display assembly (see Removing the E5400 Display Assembly).

5. Remove the display bezel (see Removing the E5400 Display Bezel).

6. Remove the display inverter (see Removing the E5400 Display Inverter).

7. Remove the eight M2 x 3-mm screws (four on each side of the display panel) from the display hinge panels.
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
NOTE: This procedure assumes that you have completed the removal procedure first.
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
1
M2 x 3-mm screws (8) (on display hinge panels)
2
display panel
3
top cover

