Figure 220. Removing the BOSS-N1 card carrier blank
Next steps
1. Replace the BOSS-N1 card carrier blank or install BOSS-N1 card carrier.
Installing the BOSS-N1 card carrier blank
The installation of the BOSS-N1 card carrier blank to the Riser 1 and 4 x 2.5-inch rear drive module is similar.
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
Steps
Align the blank with the BOSS-N1 module bay and push it into the bay until it clicks into place.
274
Installing and removing system components
To Next Page
Loading...
