Figure 221. Installing the BOSS-N1 card carrier blank
Removing the BOSS-N1 module
The removal of the BOSS-N1 module from the Riser 1 and 4 x 2.5-inch rear drive module is similar.
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
Steps
1. Pull and lift the BOSS-N1 card carrier retention latch lock to open.
2. Slide the BOSS-N1 card carrier out.
Installing and removing system components
275
To Next Page
Loading...
