Figure 258. Installing the BOSS-N1 module blank
To install the BOSS-N1 module:
1. To install the BOSS-N1 module , see installing the BOSS-N1 module steps 1 to 5.
2. To install the M.2 NVMe SSD and BOSS-N1 card carrier, see installing the BOSS-N1 module steps 6 to 10.
NOTE: Install a BOSS-N1 card carrier blank if you are only using one BOSS-N1 card carrier.
NOTE: Refer to cable routing section, configuration 49 and 50 for more information on connecting the BOSS cables to
system board connectors.
NOTE: The installation of the BOSS-N1 module to the Riser 1 and 4 x 2.5-inch rear drive module is similar.
NOTE: Installing the BOSS-N1 card carrier does not require the system to be powered off. System shutdown is only
required when installing the BOSS-N1 controller card module.
308 Upgrade Kits
To Next Page
Loading...
