Dell EMC VEP4600

To Next Page

To Previous Page

firmware_updater/diag/zlib1g-dev_1%3a1.2.8.dfsg-2+b1_amd64.deb

firmware_updater/diag/libssl-doc_1.0.1t-1+deb8u6_all.deb

firmware_updater/Yafuflash

~/UFW/temp ~/UFW/temp

Package version: x.x

Packaged images:

BMC image: x.x

BIOS image: x.xx.x.x-xx

CPLD image: XxXX

Wifi CPLD image: XxX

Note:If BMC version is less than 1.23 CPLD versions will not be shown correctly

1. Automatically update all firmware components

2. BMC image[Primary version:x.x, backup version:1.23]

3. BIOS image[Booted version: x.xx.x.x-xx]

4. CPLD image[CPLD version: XxXX]

5. rNDC left CPLD image[CPLD version: XxX]

6. rNDC right CPLD image[CPLD version: XxX]

q. Exit

4. Select the appropriate number of your choice to upgrade the firmware.

Enter your choice:1

updating ALL images

updating BMC image

****************************

* BMC version = 1.23 *

* Back-up Version = 2.0 *

****************************

updating primary image only..

INFO: Yafu INI Configuration File not found... Default options will not be applied...

Creating IPMI session via network with address xxx.xx.xxx.xxx...Done

Continuing with Full Firmware Update

****************************************************************************

WARNING!

FIRMWARE UPGRADE MUST NOT BE INTERRUPTED ONCE IT IS STARTED.

PLEASE DO NOT USE THIS FLASH TOOL FROM THE REDIRECTION CONSOLE.

****************************************************************************

Preserving Env Variables... done

Uploading Firmware Image : 100%... done

Flashing [boot] Module ....

Flashing Firmware Image : 100%... done