Dell EMC VxFlex Ready Node R740xd - Part 1 Introduction

CHAPTER 2
Configuring the hardware
This section describes how to configure the hardware, set iDRAC IP addresses, and map the ISO for servers in a VxFlex
Ready Node environment.
l
Set up the iDRAC IP address and BIOS.................................................................................................................. 18
l
Verify the status of the system hardware and drives.............................................................................................20
l
Log in to the KVM console .................................................................................................................................... 21
l
Updating the BIOS, firmware and settings.............................................................................................................22
VxFlex Ready Node Operating System Installation Guide for Linux 17