Dell EMC VxFlex Ready Node R740xd - Hardware ISO Configuration Settings

Note: The default password is Scaleio123.
Configuration settings
The Hardware ISO runs a script that automatically configures the BIOS and iDRAC settings listed in the table below.
Some settings are dependent on the server model.
Table 17 Hardware ISO configuration settings
Description Setting Value
Server BIOS Boot Sequence BIOS.BiosBootSettings.BootSeq HardDisk.List.1-1
Hard Disk Boot Order BIOS.BiosBootSettings.HddSeq Disk.SATAEmbedded.J-1,RAID.Integrated.
1-1
or
Disk.SATAEmbedded.D-1,RAID.Integrated
.1-1
Server Boot Mode BIOS.BiosBootSettings.BootMode Bios
SRIOV Global Enablement BIOS.IntegratedDevices.SriovGlobalEnabl
e
Enabled
Memory Performance Tuning BIOS.MemSettings.SnoopMode EarlySnoop
System Change Tracking BIOS.MiscSettings.InSystemCharacteriza
tion
Disabled
CPU Virtualization Features BIOS.ProcSettings.ProcVirtualization Enabled
CPU Cores BIOS.ProcSettings.ProcCores All
CPU X2APIC Mode BIOS.ProcSettings.ProcX2Apic Enabled
CPU Turbo Engagement BIOS.ProcSettings.ControlledTurbo Disabled
System Power Profile BIOS.SysProfileSettings.SysProfile PerfOptimized
OS to iDRAC Pass-through Mode iDRAC.OS-BMC.PTMode usb-p2p
OS to iDRAC Enablement iDRAC.OS-BMC.AdminState Enabled
iDRAC DHCP Enablement iDRAC.IPv4.DHCPEnable Disabled
iDRAC Default Credentials iDRAC.Tuning.DefaultCredentialWarning Disabled
iDRAC IPMI Enablement iDRAC.IPMILan.Enable Enabled
iDRAC Alert Enablement iDRAC.IPMILan.AlertEnable Enabled
iDRAC IPv6 Enablement iDRAC.IPv6.Enable Enabled
Applying settings using RACADM
The individual settings can also be applied using the remote RACADM command:
racadm -r <dracIP> -u root -p <password> set <setting> <value>
Where:
l
<dracIP> is the iDRAC IP address
Reference material
VxFlex Ready Node Operating System Installation Guide for Linux 79