Output similar to the following appears:
3. In the output, search for the lines starting with:
pci-0000:0#:00.0-sas-
where
#
is a number. (For example: 2 or 3.)
4. In the lines you just located, search for sdX at the end of the lines.
The devices paths are /dev/sdX. Use these paths when adding devices to a VxFlex OS SDS.
Retrieving device paths in a Linux server with an H730p/H740p controller
Retrieve the OS device path for a specific virtual drive (VD) in a Linux-based VxFlex Ready Node server with an
H730p/H740p controller.
Before you begin
Ensure that you have root access to the server.
About this task
In Linux servers, the OS device path is in the format: /dev/sdX, where X is a sequential letter of the alphabet in
lowercase, in single or multiple format. For example: a, b, c...z, followed by aa, ab, ac...zz.
Procedure
1. Log in to the server.
2. Display the VD information:
/opt/MegaRAID/perccli/perccli64 /c0/vall show
Output similar to the following appears:
Preparing Disks
62 VxFlex Ready Node Operating System Installation Guide for Linux
To Next Page
Loading...
