NOTE: You can use only one of the two 10 Gb Ethernet ports on each control module at a time. With the 10GBASE-T
port (left Ethernet 0 port), use CAT6 or better cable. With the SFP+ port (right Ethernet 0 port), use fiber optic cable
acceptable for 10GBASE-SR or twinax cable.
For more information, see the figures below.
Figure 7. Cabling an iSCSI SAN-Attached Cluster to a Dell EqualLogic PS4110 Storage Array
1. cluster node 1
2. cluster node 2
3. switch 0
4. switch 1
5. Dell EqualLogic PS4110 storage system
6. control module 0
7. control module 1
Figure 8. Cabling an iSCSI SAN-Attached Cluster to a Dell EqualLogic PS6110 Storage Array
17
To Next Page
Loading...
