Need help?Do you have a question about the Dell EqualLogic PS6210 and is the answer not in the manual?
General| RAID Support | Yes |
|---|---|
| Number of 10GbE Ports per Controller | 2 |
| Hot Swappable Drives | Yes |
| Drive Types | SAS |
| Network Interfaces | 10GbE |
| RAID Levels | RAID 5, RAID 6, RAID 10, RAID 50 |
| Controllers | Dual controllers |
| Management Interface | Web-based, CLI, SNMP |
| Storage Type | SSD |
| Power Supply | Dual redundant power supplies |
| Management Software | EqualLogic Group Manager |
| Compatibility | VMware, Microsoft, Linux |
| Drive Capacity | 1TB, 2TB, 4TB, 6TB |
Provides information on how to contact Dell EqualLogic Technical Support via phone and web.
Details where to find warranty information included in the shipping box and how to register a warranty.
Explains the meaning of NOTE, CAUTION, and WARNING symbols used in the manual for safety.
Details the form factors, control modules, Ethernet ports, and ReadyRails II support of the PS6210 array.
Instructions on protecting the PS Series array from electrostatic discharge using anti-static wrist straps.
Describes the front-panel features and indicators of the PS6210 array, referencing figures and tables.
Procedure for cleanly shutting down and restarting the PS Series array, including network and serial connection methods.
Methods to identify failed drives, including LEDs, console messages, and Group Manager status.
Explains the meaning of LEDs on 3.5-inch and 2.5-inch drives for status indication.
Guidelines for safely handling, storing, and installing drives, emphasizing ESD protection and proper packaging.
Rules for installing drives, including type, capacity, orientation, and the automatic configuration delay.
Step-by-step instructions for safely removing a 2.5-inch drive from the array using the release button and handle.
Step-by-step instructions for inserting and securing a 3.5-inch drive into the array, ensuring proper seating.
Details the features of the Type 15 control module, including Ethernet ports, management port, and status LEDs.
Methods to identify control module failures using LEDs, console messages, and Group Manager status.
Overview of procedures for replacing a failed control module or its microSD card.
Instructions for replacing the microSD card containing firmware, especially when replacing a control module.
Guidance on replacing the battery within a PS Series array control module, noting service technician requirements.
Methods to identify PSU failures using LEDs, console messages, and Group Manager status.
Describes the LEDs on power supply and cooling modules that indicate their operational status.
Instructions for safely removing a PSU module, including turning off power, disconnecting cables, and using the release latch.
Step-by-step guide for installing a power supply and cooling module, ensuring it is fully seated and latched.
Emphasizes that repairs should only be done by certified technicians or as directed by Dell support.
Checks to perform if the system halts during startup, including array fault LEDs and drive sounds.
Troubleshooting steps for loss of array connections, checking control module LEDs and cable attachments.
Troubleshooting steps for power supply failures, including checking LEDs, power source, and reseating the module.
Steps to troubleshoot control module failures by checking status LEDs and reseating the module.
Steps to identify and replace faulty hard drives, confirming the issue via GUI or logs before removal.
To Next Page