Dell Force10 S2410-01-10GE-24P - The S2410 System; Physical Interfaces; Required Equipment

The S2410 System | 7
2
The S2410 System
This chapter contains these sections:
• Physical Interfaces
• Required Equipment on page 7
• Features on page 8
• Ports on page 8
• System Status on page 9
Physical Interfaces
The Dell Force10 S2410 is a Layer 2 switch that is available in two models — the S2410CP and the
S2410P. The primary difference is that the S2410P contains 24 built-in 10-gigabit Ethernet (10G) XFP
ports, while the S2410CP contains 20 built-in 10G BaseCX4 ports and four 10G XFP ports.
Figure 2-1. The S2410CP (Front View)
Figure 2-2. The S2410 (Rear View
)
Required Equipment
The following items are necessary to install the S2410 system:
• Two grounded AC power sources
10/100 Ethernet Management Port
Status LEDs
Console Port
20 XFP Ports (S2410P)
20 CX4 Ports (S2410CP) or
4 XFP Ports
Label
(Assembly and Serial #)
070-00285-00-1
10/100 Ethernet Management Port
Status LEDs
Console Port
20 XFP Ports (S2410P)
20 CX4 Ports (S2410CP) or
4 XFP Ports
Label
(Assembly and Serial #)
070-00285-00-1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
S2410-01-10GE-24CP
10/100
Console
Ethernet
Alarm
PSU-A
PSU-B
L
A
L
A
L
A
L
A
L
A
L
A
L
A
L
A
L
A
L
A
L
A
L
A
L
A
L
A
L
A
L
A
L
A
L
A
L
A
L
A
L
A
L
A
L
A
L
A
CLASS 1 LASER PRODUCT
LASERPRODUKT DER KLASSE1
Catalog #
System
Serial #
Serial #
Assy
Assy
fn00158s241
0
Dual AC Power Receptacles
Vents