4. Disconnect the camera cable from the system board.
5. Flip the computer over and place the computer on a clean and flat surface.
6. Remove the antenna cable and display cable from the routing guides on the palm-rest and keyboard assembly.
7. Remove the eight screws (M2.5x4) that secure the display-assembly hinges to the palm-rest and keyboard assembly.
8. Lift the hinges from the palm-rest and keyboard assembly.
9. Slide and lift the display assembly off the palmrest and keyboard assembly.
10. After performing all the above steps, you are left with the display assembly.
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display assembly and provides a visual representation of the installation
procedure.
32
Removing and installing components
To Next Page
Loading...
