Steps
1. Insert the ethernet and audio board at a 45 degree angle into the slot on the system board.
2. Align the screw holes on the ethernet and audio board with the screw holes on the system board.
3. Install the two screws (M2x4) that secure the ethernet and audio board to the system board.
Next steps
1. Install the system board.
2. Install the memory module.
3. Install the wireless card.
4. Install the solid-state drive.
5. Install the rear cover.
6. Install the battery.
7. Install the base cover.
8. Follow the procedure in After working inside your computer.
Power button
Removing the power button
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the rear cover.
5. Remove the solid-state drive.
6. Remove the wireless card.
7. Remove the memory module.
8. Remove the system board.
NOTE:
System board can be removed with the fan and heat-sink assembly, ethernet and audio board, and USB board
attached.
Removing and installing components 47
To Next Page
Loading...
