7. Remove the memory module.
8. Remove the system board.
NOTE: System board can be removed with the fan and heat-sink assembly, ethernet and audio board, and USB board
attached.
Steps
1. Turn the system board over.
2. Remove the two screws (M2x4) that secure the ethernet and audio board to the system board.
3. Disconnect and remove theethernet and audio board from the system board.
Installing the Ethernet and audio board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the ethernet and audio board and provides a visual representation of the
installation procedure.
46
Removing and installing components
To Next Page
Loading...
