Dell G3 15 - Removing the solid-state drive;Intel Optane

Identifier GUID-EFFE3DA7-AFC7-4BB0-92C9-4A1B23C2F2F5
Status Released
Removing the solid-state drive/Intel Optane
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Identifier GUID-5BAAC44D-C63C-4E84-8264-5FBA1D4F995B
Status Released
Prerequisites
Remove the base cover.
Identifier GUID-14019E80-3BC4-4DA7-AC79-3E2EEE35266E
Status Released
Procedure
1 Loosen the captive screw that secures the solid-state drive shield/Intel Optane shield and solid-state drive/Intel Optane to the palm
rest and keyboard assembly.
NOTE
: Solid-state drive shield is available only on computers shipped with NVMe solid-state drive.
2 In computers shipped with mSATA solid-state drive/Intel Optane, remove the screw (M2x3) that secures the solid-state drive/Intel
Optane to the palm rest and keyboard assembly.
3 Slide the solid-stare drive shield/Intel Optane shield and lift the solid-state drive shield/Intel Optane shield o the palm rest and
keyboard assembly.
4 Slide and remove the solid-state drive/Intel Optane from the slot.
17
Removing the solid-state drive/Intel Optane 37