Steps
1. Connect the battery cable to the system board, if applicable.
2. Connect the LED cable to the system board, if applicable.
3. Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly, and then snap the
base cover into place.
4. Replace the six screws (M2x7) that secure the base cover to the palm-rest and keyboard assembly.
5. Tighten the four captive screws that secure the base cover to the palm-rest and keyboard assembly.
Next steps
1. Follow the procedure in After working inside your computer.
Light bar
Removing the light bar
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
NOTE:
Please note that this procedure is applicable only for computers shipped with Nvidia GeForce GTX 1660 Ti/Nvidia
GeForce RTX 2060/Nvidia GeForce RTX 2070 MQ.
16 Removing and installing components
To Next Page
Loading...
