Steps
1. Slide the power-button module into the chassis until it snaps into place.
2. Connect the power-button cable to the system board.
Next steps
1. Install the 3.5-inch hard drive.
2. Install the left-side cover.
3. Follow the procedure in After working inside your computer.
Processor fan and heat-sink assembly
Removing the processor fan and heat-sink assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before
you touch it.
CAUTION: For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in
your skin can reduce the heat transfer capability of the thermal grease.
2. Remove the left-side cover.
About this task
The following images indicate the location of the processor fan and heat-sink assembly and provides a visual representation of the removal
procedure.
The processor fan and heat-sink assembly on your computer may differ based on the configuration ordered.
32
Removing and installing components
To Next Page
Loading...
