Palm Rest | 31
Replacing the Palm Rest
Procedure
1 Slide the status-lights cable into the connector on the system board and press
down on the connector latch to secure the cable.
2 Align the palm rest with the computer base and gently snap the palm rest into
place.
3 Slide the hot-key board cable, power-button board cable, and touchpad cable into
the connectors on the system board and press down on the connector latches to
secure the cables.
4 Replace the screws that secure the palm rest to the computer base.
5 Turn the computer over and replace the screws that secure the palm rest to the
computer base.
Postrequisites
1 Replace the base cover. See "Replacing the Base Cover" on page 18.
2 Replace the keyboard. See "Replacing the Keyboard" on page 16.
3 Replace the battery. See "Replacing the Battery" on page 13.
4 Follow the instructions in "After Working Inside Your Computer" on page 9.
To Next Page
Loading...
