NOTE: This is the heatsink for your computer that supports the integrated Graphics Processing Unit (GPU).
Steps
1. Align the screw holes on the heat sink to the screw holes on the system board.
2. In sequential order (1>2>3>4>5>6>7) or (1>2>3>4), tighten the seven or four captive screws, whichever is applicable, that
secure the heat sink to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following image(s) indicate the location of the display assembly and provides a visual representation of the removal
procedure.
Removing and installing components
37
To Next Page
Loading...
