Removing the antenna
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Prerequisites
1 Remove the stand.
2 Remove the back cover.
3 Remove the system-board shield.
4 Remove the wireless card.
Procedure
1 Note the routing of the antenna cables, and remove it from the routing guides on
the display-assembly base.
2 Remove the two screws (M2x2.5) that secure the antennas to the display-
assembly base.
36
To Next Page
Loading...
