5. Install the memory modules.
6. Install the M.2 2230 solid-state drive, if applicable.
7. Install the M.2 2280 solid-state drive, if applicable.
8. Install the base cover.
9. Follow the procedure in After working inside your computer.
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the M.2 2230 solid-state drive, if applicable.
4. Remove the M.2 2280 solid-state drive, if applicable.
5. Remove the fan.
6. Remove the wireless card.
7. Remove the display assembly.
8. Remove the system board.
NOTE: The system board can be removed along with the heat sink.
About this task
The following images indicate the location of the power-adapter port and provides a visual representation of the removal
procedure.
Steps
Lift the power-adapter port from its slot on the palm-rest and keyboard assembly.
60
Removing and installing components
To Next Page
Loading...
