Steps
1. Lift the Mylar that covers the system board.
2. Lift the thermal tape that covers the M.2 2280 solid-state drive.
3. Remove the screw (M2x3) that secures the M.2 2280 solid-state drive to the palm-rest and keyboard assembly.
4. Slide and remove the M.2 2280 solid-state drive from the M.2 card slot on the system board.
Installing the M.2 2280 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE: This procedure applies if you are installing a M.2 2280 solid-state drive.
NOTE: The M.2 card that is installed on your computer will depend on the configuration ordered. Supported card
configurations on the M.2 card slot:
● M.2 2230 solid-state drive + 2230 mounting bracket
● M.2 2280 solid-state drive
Removing and installing components 23
To Next Page
Loading...
